Test Equipment

• How to put to good use the GPIB connector on the back of test equipment
• Tektronix 494P spectrum analyzer repair
• Signal Generators HP 8656A, HP 8657B and HP 3586A compared
• Effect of cable impedance and termination impedance on signal waveform.
• A Simple Dynamic Load to Check Power Supplies and Battery Chargers.
• Tektronix 7L18, 492 and 494P Spectrum Analyzers compared.
• Discussion about Tektronix Serial Numbers.
• Phase Locking a sweeper using the EIP 371 Source Locking Microwave Counter
• A Single Chip Synthesized AF Signal Generator with easy calibration.
• Using a Coax to Waveguide adapter as an antenna for EMI check.
• Noise Figure Measurements when you don't have an HP 3048A Noise Figure Test Set
• Considerations on Antenna Pattern Measurements, near field versus far field
• Effect of Pulse Width on Frequency Spectrum

Except as noted, this entire site Copyright © 2002-2008. KO4BB All rights reserved.