[MyHosting.com]   [Home Page]   [Manuals]   [KO4BB Wiki]
Help keep this site free:
(More Info)

Microwave Oven Leakage

Following a thread on the Time-Nuts mailing list, I wanted to check the RF leakage from my Sears microwave oven.

This is a relatively expensive model, intended to be bolted to the wall above the cooking range. Some table-tops models can be bought for much less than $100, but this model was about $600 if I recall correctly.

Here is the setup:

The Spectrum analyzer senses RF through a small rubber duckie antenna from a VHF walkie talkie. The antenna is about 1 foot from the oven, somewhat aligned with the seam along the lower left corner of the door.

And here is the data, collected with the spectrum analyzer in peak-hold mode for about 2 minutes.

Please note the peak level is almost +30dBm (1W!!!) and the occupied bandwidth is almost 100 MHz.

I am not sure what the regulations are for this type of equipment, but 1W peak sounds high to me.

I later looked at the signal with a crystal detector driving a scope (not storage), and the signal shape is roughly that of a 60Hz sinewave half-wave rectified, indicating that this oven uses a simple transformer-based supply, not a switching supply. I will try to take a picture of the signal with the storage scope later and post a picture here.


Return to Main Page


Except as noted, this entire site Copyright © 2002-2016. KO4BB All rights reserved.
October 02 2014 09:24:36