This shows you the differences between two versions of the page.
|
precision_timing:store_position_on_trimble_thunderbolt [2013/01/08 19:00] |
precision_timing:store_position_on_trimble_thunderbolt [2013/01/08 19:00] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Store Position On Trimble Thunderbolt ====== | ||
| + | //John Miles, jmiles at pop.net// | ||
| + | |||
| + | //Wed Feb 6 23:05:00 EST 2008// | ||
| + | |||
| + | ---- | ||
| + | |||
| + | ==== Message: [time-nuts] Setting Trimble Thunderbolt Stored Position ==== | ||
| + | |||
| + | Short answer: go to Setup->Self-Survey, make sure the Enable and Save buttons are clicked, then hit "Set Survey," "Save Segment," and "Close." After that, do a Control->Restart Self-Survey. The alarm indication should go away once the survey process finishes. | ||
| + | |||
| + | You do not need to copy anything manually unless you want to specify a more-accurate survey position than what the Thunderbolt arrives at on its own. | ||
| + | |||
| + | -- john, KE5FX | ||