[MyHosting.com]   [KO4BB Home Page]   [Manuals Home Page]   [KO4BB Wiki]
 

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

test_equipment:hp8350_known_issues [2013/01/08 19:00]
test_equipment:hp8350_known_issues [2013/01/08 19:00] (current)
Line 1: Line 1:
 +====== HP8350 Common Issues. ======
  
 +
 +
 +The HP8350A and 8350B is getting common on ebay and other used equipment places. Most generators are getting old and there are several known issues. Before starting fault finding an main frame or plug-in, http://​www.hparchive.com/​Journals/​HPJ-1982-02.pdf should be read. 
 +
 +
 +==== Option 001 instruments with leaking battery. ====
 + 
 +
 +The battery consist of 3 AA NI-CD cells, that after some years start leaking. If caugth before the leaking starts, the batterys can be replaced and excanged for 3 regular NI-CD or NI-MH batterys. If they have started to leak, one option is to remove the batterys, and clean the holder in hot water with some dish detergant and an old toothbrush (use gloves). As an alternative,​ the battery can be removed, the generator should work without the battery, but would not remember the frequency or markers after power off. If the battery are leaking, make sure you clean all the cards, contacts and surounding surfaces. The battery is placed so that if it leaks, it will leak all over the GPIB and processor board, A7 voltage regulator board and main board. ​
 +
 +
 +==== E001 Error. ====
 +
 +
 +This error means there are no plug-in in the main frame. If all leds on the power supply board is ligth, check the card contacts and the connectors between the main frame and plug-in. ​
 +
 +
 +
 +==== E004 Error. ====
 +
 +
 +The most common error is leaking tantal capacitors on the A7 board. Replace all of them, they will go bad after some time. If all supplys are found to be within tolerance, take an look around the op-amp U17 on A7 board.
 +
 +==== Attenuator issues. ====
 +
 +
 +Several of the plug-ins use the HP33321 attenuator that may have one or several sections stuck. An good cleaning and replacement of the o-rings help. The following are reported to be an good replacement:​
 +
 +O-rings, NBR, 70 Shore.
 +
 +
 +
 +==== Firmware ====
 +
 +
 +The latest firmware for the A verson is ? and for the B version it's 7. To find the FW version press SHIFT 49.
 
test_equipment/hp8350_known_issues.txt ยท Last modified: 2013/01/08 19:00 (external edit)
 
Recent changes RSS feed Creative Commons License Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki
Except as noted, this entire site Copyright © 2002-2017. KO4BB All rights reserved.