This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
yamaha_fz1:hid_projector_upgrade [2016/02/11 08:47] ko4bb |
yamaha_fz1:hid_projector_upgrade [2016/04/01 21:14] ko4bb |
||
---|---|---|---|
Line 38: | Line 38: | ||
{{:yamaha_fz1:hi_beam.jpg?400}} | {{:yamaha_fz1:hi_beam.jpg?400}} | ||
+ | |||
+ | It was a little harder to put the rubber boots back but it does fit if you pull the center part out: | ||
+ | |||
+ | {{:yamaha_fz1:hid_boot.jpg?400|}} | ||
==== Startup interlock ==== | ==== Startup interlock ==== | ||
Line 50: | Line 54: | ||
I have designed a similar circuit for my bike. It only requires a relay, a SCR and a handful of passive components. | I have designed a similar circuit for my bike. It only requires a relay, a SCR and a handful of passive components. | ||
+ | |||
+ | {{:yamaha_fz1:hid_interlock.jpg?400|}} | ||
+ | |||
+ | Here is the schematic: | ||
+ | |||
+ | {{:yamaha_fz1:hid_switch.png?400|}} | ||
+ | |||
+ | Note: the terminal referenced as "+VBat" in fact should be connected to the switched 12V, otherwise the circuit will draw current all the time and it would never turn off. I took power from the unused "running lights" harness in the fairing. | ||
+ | |||
+ |